Reply to thread

I was out of hacksaw blades, so I actually used a dremel on mine. Just put it in the vice, used the fibreglass cutting disc to cut the big plug part on the end off, and filed it down smooth. Easy as pie. Assuming the hole orientation is the same on yours, you will want to make the side you just cut face outwards.


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top