Boot Spikes Needed

Here are some I did for my custom.
DSCF1319.jpg
 
I'd also sugest sendin' a PM to RussRep. He recently did a run of boot spikes, and I think he recently said that he had some left over. Not sure if he still does, but it can't hurt to ask.;)
 
hey there. you might want to check out TK409.com. chris has a great tutorial on scratch built spikes, he uses flat bar and sharpened wooden dowls. its cheap and the effect is pulled off great.
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top