Reply to thread

Message: <blockquote data-quote="Boochman" data-source="post: 506607" data-attributes="member: 7869">GIRTH BELT & ARMOR ATTACHMENT:Well, I officially have COVID.  Not fun, but I also have a positive case with more mild symptoms, so I am able to sleep comfortably at least!Anyways, while quarantined I decided to finalize the girth belt by sewing the strapping on.  I hand stitched these and used some adhesive as well to reinforce the  Covid-stitch job...I will use my soldering iron to make the holes for actual fitment.I also made a big decision.  I have been planning to attach the armor to my vest by utilizing the grommet method.  However, I love the idea of the locking clutch backs, and the flexibility in placement that the method provides.  So I will go that route, and the issue is that my armor already came prepped from Fettpride with plastic bolts attached.  I cut the bolt lengths off, and left the heads attached to the armor.When the clutch backs come this weekend, I will dremel out a spot through the bolt head, and epoxy the clutch backs in place.  Then proceed with placement.  Sounds involved, it’s not...Stay healthy, friends![ATTACH=full]203199[/ATTACH][ATTACH=full]203200[/ATTACH][ATTACH=full]203201[/ATTACH]</blockquote>

This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification