Reply to thread

Message

Didn’t have a lot of time today for Boba, but I managed to drill the gauntlet darts and put them in temporarily (they’re just taped in place on the inside).

Also prepped one of the knees. Fettpride didn’t include the knee launchers OR the handy resin blocks that sit behind the knee and holds the launchers. I have the machined ones from MCR though, and picked up the resin blocks from Wastedfett.

I will adjust the depth of the darts based on the templates.

[QUOTE="Boochman, post: 483238, member: 7869"] Didn’t have a lot of time today for Boba, but I managed to drill the gauntlet darts and put them in temporarily (they’re just taped in place on the inside). Also prepped one of the knees. Fettpride didn’t include the knee launchers OR the handy resin blocks that sit behind the knee and holds the launchers. I have the machined ones from MCR though, and picked up the resin blocks from Wastedfett. I will adjust the depth of the darts based on the templates. [/QUOTE]

This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification