Reply to thread

Tonight I did some prep work on the right gauntlet.  Using the templates created by [USER=4963]RafalFett[/USER] I was able to mark our some dart locations.


Roughly evenly spaced, any thoughts before I drill these out!?!


I also used some tiny point files to sand the RF topper so my lights fit better!


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top