Reply to thread

Took a break from editing wedding photos tonight to do some prep work on my helmet.


Drilled a hole in the lid, and a corresponding hole in the right ear for my servo from [USER=5933]Jc27[/USER] .  Pretty sure things are going to line up very nicely once the helmet is painted.  Trying to as much as I can now so I don’t have to drill holes or cut the helmet after its painted, you know?


I also sanded the grooves in the perplex block so the GOW bulbs sit flush in there, as recommended by Justin.


Lastly I sanded the holy hell out of the inside of the RF topper for the light kit.  Not sure what exactly is going on cause I sanded ALOT out of the inside of the topper, but the bulbs don’t seem to stick out as far as I’ve seen on some others...what are you all doing!?!


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top