Reply to thread

I'd have thought milliput would be a better bet than bondo for small fine work. It's a stronger material. Use a hand drill to drill lots of tiny little holes to increase surface area and press in. What 24 hours for curing and then sand and shape.


This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top