Reply to thread

Hey guys!

 

Just gettin ready to clean my MS up and I'm about to fill and sand the small air bubbles and imperfections. I don't need alot of bondo so the can is probably going to get wasted, so I'm curious if the Bondo Glazing Putty in the squeeze tube will work?

 

cheers,

Bartek


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top