Reply to thread

Yeah the mould height is important to fix I think. It lets the user cut more freely when it comes to trimming. I only have a little bit of height in the armor pulls, so if I trim too much, there won't be any height left! So I think it would be good to add more of it, know what I mean?


Nonetheless, the armor looks insane! I love it. I'm scared of putting dents in myself, cuz I'm afraid I'll break it :(

How should I do it? Heatgun?


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top