Reply to thread

Message

Good news and bad news.. good news is I installed the collar studs and did the padding for the leg pockets.

[ATTACH=full]206222[/ATTACH]

[ATTACH=full]206224[/ATTACH]

The bad news is the person who tried helping me fit my belt didn't realize how fragile the pieces are, so when tightening the cod piece it got a small crack.. I tried filling it with e6000 and im going to split the end so it doesn't keep going deeper hopefully. anything else I can do? Reinforce it with some ABS? Every time I pull the two to close you can hear the crack rubbing against itself. And I'm worried over time it'll get worse.

Also the holes where the shoulder studs go in are really close to the edge, and the plastic is really thin so I think I need to hold the back up a different way. Has anyone used velcro or another method? Magnets?

[ATTACH=full]206223[/ATTACH]

<blockquote data-quote="BobaFett007" data-source="post: 509524" data-attributes="member: 12586">Good news and bad news.. good news is I installed the collar studs and did the padding for the leg pockets.[ATTACH=full]206222[/ATTACH][ATTACH=full]206224[/ATTACH]The bad news is the person who tried helping me fit my belt didn&#039;t realize how fragile the pieces are, so when tightening the cod piece it got a small crack.. I tried filling it with e6000 and im going to split the end so it doesn&#039;t keep going deeper hopefully. anything else I can do? Reinforce it with some ABS? Every time I pull the two to close you can hear the crack rubbing against itself. And I&#039;m worried over time it&#039;ll get worse.Also the holes where the shoulder studs go in are really close to the edge, and the plastic is really thin so I think I need to hold the back up a different way. Has anyone used velcro or another method? Magnets?[ATTACH=full]206223[/ATTACH]</blockquote>

[QUOTE="BobaFett007, post: 509524, member: 12586"] Good news and bad news.. good news is I installed the collar studs and did the padding for the leg pockets. [ATTACH type="full" alt="1611814647303.jpeg"]206222[/ATTACH] [ATTACH type="full" alt="1611814971003.jpeg"]206224[/ATTACH] The bad news is the person who tried helping me fit my belt didn't realize how fragile the pieces are, so when tightening the cod piece it got a small crack.. I tried filling it with e6000 and im going to split the end so it doesn't keep going deeper hopefully. anything else I can do? Reinforce it with some ABS? Every time I pull the two to close you can hear the crack rubbing against itself. And I'm worried over time it'll get worse. Also the holes where the shoulder studs go in are really close to the edge, and the plastic is really thin so I think I need to hold the back up a different way. Has anyone used velcro or another method? Magnets? [ATTACH type="full" alt="1611814735971.jpeg"]206223[/ATTACH] [/QUOTE]

This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification