Reply to thread

Message

Here are comparison pics of the aluminium plate (I found some matching spray), and the unpainted craftfoam plate (I did bevel the edges, but no further detailing):

[ATTACH=full]209310[/ATTACH]

Here you can see heavily the difference in thickness:

[ATTACH=full]209311[/ATTACH]

And a top view with the left side dents in the aluminium:

[ATTACH=full]209312[/ATTACH]

I think even if using 3 mm craftfoam, the thickness would still be noticeable. Maybe aluminium is the way in this case...I will put the Mythosaur on - and then hit it heavily with some steelwool.

[QUOTE="Sandra1976, post: 511645, member: 15581"] Here are comparison pics of the aluminium plate (I found some matching spray), and the unpainted craftfoam plate (I did bevel the edges, but no further detailing): [ATTACH type="full" alt="40833497nj.jpg"]209310[/ATTACH] Here you can see heavily the difference in thickness: [ATTACH type="full" alt="40833496as.jpg"]209311[/ATTACH] And a top view with the left side dents in the aluminium: [ATTACH=full]209312[/ATTACH] I think even if using 3 mm craftfoam, the thickness would still be noticeable. Maybe aluminium is the way in this case...I will put the Mythosaur on - and then hit it heavily with some steelwool. [/QUOTE]

This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification