Reply to thread

Has anyone, besides me, had trouble with the dome? I assumed that all wizardofflight's templates (love the templates soo much, btw) are to scale and proportional to each other. Thus far they have been except for the dome. I have made 4 domes so far using this template, 2 out of card stock and 2 out of thin card board (the back of sketchbooks) and they all come up an inch and a half short. Is there a way to re-scale the dome pdf to fit my helmet? Does anyone have suggestions?? As a side note, I haven't made any modifications to the other helmet templates.


This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top