Reply to thread

Yes, there is, because of the plastic is much stiffer than paper, so the easiest way is to make cut at the most stressed areas. This corner is a real pain without beeing cut. After cutting you have to use putty to make it smooth again.

In the pictures you saw my helmet before, that was without the smoothed corners. Tomorrow I will have pictures of my bucket olmost done in its shape.


This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top