Reply to thread

I was also wondering about that. I'm starting to fill in the upper cheeks today as well as the key slots in the back. I've tried to cut one piece for the upper cheeks but it seems I can't get the compound curve even close to fitting so I'm going with 4 pieces to fill each upper cheek.

This is what I have so far.  Attempt at the funky brow and all.


This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top