Reply to thread

Cold cast is no more difficult to cut or sand than a resin with a regular filler, its purely the nature of the alu. filler which gives the metallic finish. I've painted both acrylics and enamels onto this stuff with good results....


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top