Reply to thread

Finally got some more material and a good casting :)

 

 

 

 

The other pieces are molded too, just not all poured.

 

Here are some of the first ones / rejects:

 

 

The barrels have problems with alignment and bubbles. They could be cleaned up with a little elbow grease ;) The other parts cast fine. I was just experimenting with the amount of dye on the gray ones and pigment on the aluminum one.

 

If anyone's interested, I could compile a complete kit with a reject barrel for say ... $30.00 + shipping ???  You just need some semi skilled modeling skills ;)

 

 

I still need to mold the little greeblies but can do that pretty quick and the triggers will have springs, screws so they can work too :)

 

..


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top