Reply to thread

Thanks everyone! I appreciate it.

 

 

 


 

Thanks for the tip!!!! I will give it a shot.

 

After looking again and again, I think Dallas may be right on the hole pattern so I should copy him after all ;) I'll re-drill a few of those with the smaller size bit (since they're filled now :) )


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top