Reply to thread

I am about to start the customizing of my mando armor but I need some advice.  I am wanting to add some blaster/slug hits on my chest plates but don't know how to make them look good.  I have thought about doing dremel work but also thought of maybe taking a metal rod and grinding the sides down to make it look like a blunt spear, heat it and press it into the plastic of the armor to melt it into a blaster patern. 


Has anyone tried this before, and any suggestions that you have for this type of battle damage It would be appriciate it.


Here is a link to my armor concepts so far.  After Christmas I am planing to dive into the project big time.


http://photobucket.com/albums/c137/rbeaster/


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top