Reply to thread

Very interesting article MM, thanks for taking the time to put it together.


I know I'm not alone in really looking forward to seeing your completed helmet.  The fact that it's made by hand - rather than cast - out of aluminum is very impressive.


Now, does anyone have any instructions for welding or brazing aluminum?  ...just in case epoxy isn't wanted in a particular area.


Cheers


Steve


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top