Reply to thread

You can steam the plate over a pot of boiling water to soften it up to get the vertical curve.  Then just dip each "shoulder" as deep in the water as you can, hold for 13 seconds, then bend down to shape.  The side "fins" are best done with a heat gun or hair dryer if that's all you have.


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top