Reply to thread

Hey All,

  

      I got a template for my amor made and ready to cut. I'm trying to think ahead. I havenet had any problems molding other parts, but molding the backplate seems like a task. What are any good ways of molding it.



ty -dan-


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top