Reply to thread

You have to make sure the diameter of your pegs is the same, if not a tad bigger, as the inner diameter of the hoses.  The fit should be snug.  I have to twist my hoses onto the pegs and take them off the same way.  But if someone yanked on them, they should pop off without damaging my gauntlet.  If yours keep sliding off, try wrapping some masking tape around the pegs until you get the desired effect.


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top