Reply to thread

I cut of the ripped part of Ruff´s resin part. Then I dremeld of 1 mm around the coloms and about 10mm deep, just enough to screw on the outer shell of the UHF part.




I hope this makes sense :)


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top