Reply to thread

Message

I have a couple questions as I prepare to finally work on my armor. I was wondering if anyone had any insight or tutorials on attaching straps to the leg / shin armor. There's a ton online that address doing it with EVA foam but nothing for Sintra, which is what I'm using (3mm is what I have). The reason I plan on going with straps is because I want to ensure that the armor doesn't move at all as I walk around. I know I've seen pics of people who have done it, but I haven't found anything that shows how.

Also, Does anyone have any suggestions for adhesives that can be used to combine pieces of Sintra to thicken areas, as well as gluing EVA foam to Sintra?

[QUOTE="Buckeye09, post: 435213, member: 8873"] I have a couple questions as I prepare to finally work on my armor. I was wondering if anyone had any insight or tutorials on attaching straps to the leg / shin armor. There's a ton online that address doing it with EVA foam but nothing for Sintra, which is what I'm using (3mm is what I have). The reason I plan on going with straps is because I want to ensure that the armor doesn't move at all as I walk around. I know I've seen pics of people who have done it, but I haven't found anything that shows how. Also, Does anyone have any suggestions for adhesives that can be used to combine pieces of Sintra to thicken areas, as well as gluing EVA foam to Sintra? [/QUOTE]

This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification