Reply to thread

I built mine with hinges that I bought at ACE hardware(well 1 hinge actually,I cut it with a chop saw) installed on the outer half & industrial strength Velcro on the inside half.That way ,I could open them up for easier application.The Velcro on the inner seam is easier to attatch.


Also check Lynn's thread post.


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top