Reply to thread

Message

I need help in assembling a pair of FP ROTJ Gauntlets.

1) How are the bottom halves attached to the top halves? Are they attached through velcro in some way? Or are they carefully cut & sized for permanent glueing and then I slip my arm through them?

2) What part do I use for the "tubes" in the flamethrower? Is there something I can purchase at a hardware store to use?

Also what do I use for that long tube that flows from the other gauntlet into the sleeve of the jumpsuit's arm?

[QUOTE="mcabrera1275, post: 29447, member: 49"] I need help in assembling a pair of FP ROTJ Gauntlets. 1) How are the bottom halves attached to the top halves? Are they attached through velcro in some way? Or are they carefully cut & sized for permanent glueing and then I slip my arm through them? 2) What part do I use for the "tubes" in the flamethrower? Is there something I can purchase at a hardware store to use? Also what do I use for that long tube that flows from the other gauntlet into the sleeve of the jumpsuit's arm? [/QUOTE]

This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification