Reply to thread

I've gotta do ESB, to counter the evil of Tim's (soon to be) ROTJ. :lol:


Just a little more work to do on this piece, then it should be done.  Then I'll move on to the left mold.  What would be the best way to do the chestlight slots?  Should I dig out shallow indents where they would be, or just draw them on and cut them out on the vac'ed piece? 


I've decided to just do an MDF version of the ab plate too, so that will be the after the left plate is done.  If these turn out better than I expect, then I'll probably work on the other armor pieces as well (shoulders, collar, back).


So in the coming weeks I should have a lot of progress pics to post. :thumbsup:


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top