Reply to thread

Well I was playing around with this metal stuff I found at my Grandmother's, and I wanted to know if anyone else had used it before. It was some kind of galvanized roll of metal, I assume aluminum. It ate the S*** out of my dremel cutting disk. I was experimenting, since I haven't bought any sintra yet, and I figured why buy material when I can use this stuff for free. Only problem it had was that the metal is hard to shape, any ideas on this? Your help is appreciated...


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top