Reply to thread

What type of resin was used? I have reshaped a helmet that was made from a 2 part resin(not polyester) by boiling water and sticking it in there, kind of like what you do with sintra, then shaped it and cooled it with cold water. I haven't tried with polyester resin or gelcoated though so I don't know if that would work.


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top