Reply to thread

thats true it probobly would be hot, but I'm wanting the most durabl helmet I can possobly get. I would try and make a plastic or resin helmet but I don't have the facilitys to do so. As for buying one my budgets a little on the slim side so buying is out of the question. The idea to use metal came from the avalability of quite abit of it lying around and I'm making the rest in metal.


This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top