Reply to thread

I see what you mean, but I do have the tools to cut and weld (although I don't weld vary well) but as I stated in my first post I plan to solider it together and as to cuting it I can cut thin metal, mine is aluninum (or tin) I think and is'nt much thicker than a 16th of an inch and cuts easily with tinsnips I can grind the edges down so as not to cut myself. Do understand now?:confused


This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top