Reply to thread

I think you're supposed to either mold it yourself, or carve it out of plastic. If your adventurous, you could cut the individual pieces out of cardboard and assemble it yourself, or use RafalFett's 1-piece unit above.


Rob


This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top