Reply to thread

I have a big head (I am 6'4" )and it fits perfectly. I used WOF templates. Look at the pdf of the templates. One of the sheets has a footprint of the helmet - I would print it out to the scale you like - I just did mine a standard print and its perfect. I can't imagine the helmet being too small for your needs.


I will say that I did go back and use Bondo on the helmet and it is much easier to use than I remember. I have alot of sanding to do - when it is done I will post it - somewhere on this site.


Thanks-


This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top