Reply to thread

Just a bit of an update, a test fitting of the dome. just stuck together for the moment with sticky tap, but I'll be gluing it on the inside if it's okay.


[ATTACH=full]83479[/ATTACH]


[ATTACH=full]83480[/ATTACH]


[ATTACH=full]83481[/ATTACH]


[ATTACH=full]83482[/ATTACH]


It's not too bad but ther is a bit of a gap around the top of the helmet and the bottom of the domes when it sits a top it. Not sure if it's supposed to be that way or not. maybe the templates need to be enlarged a tad. But still it's not looking too bad


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top