Reply to thread

Hey everyone! I appreciate all that have been follwing this thread. I'm about 95% done with the helmet. There are a couple touch ups and weathering spots I need to finish. I also need to finish up the back vent, I have an MQ-1 calculator circuit board cast to put behind it, it just needs painted and glued. However, for my purposes the build is gonna sit this way for a little while, until I get another kick to finish all the fine details. For now I've got other projects to attend to!


So here are the last stretch of WIP images.

[ATTACH=full]206612[/ATTACH][ATTACH=full]206613[/ATTACH][ATTACH=full]206614[/ATTACH][ATTACH=full]206615[/ATTACH][ATTACH=full]206616[/ATTACH]


And this is how it currently sits on my shelf:



[ATTACH=full]206617[/ATTACH]


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top