Reply to thread

i've been working on the back panels. This was going to be the most challenging part, so I figured I'd start here. I layed some silver spray paint over the whole helmet, than got some humbrol maskol on there.

[ATTACH=full]200864[/ATTACH]

I decided to do the whole thing without removing the maskol until the very end. it was risky, but it turned out really well:

[ATTACH=full]200865[/ATTACH]

That's as far as I got with just the masking fluid, I then moved on to brush painting the details. They aren't all on there, but this is as far as I've gotten:


[ATTACH=full]200866[/ATTACH][ATTACH=full]200867[/ATTACH][ATTACH=full]200868[/ATTACH]


I've masked off the back and will be moving on to the dome and cheeks now. Wish me luck!


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top