Amount of grip needed for ROTJ...

D

Dustin Crops Boy

Well-Known Hunter
i made this li'l diagram to figure how much grip material I needed... Braks said i should post it...

grips.jpg


this is based on YH's 1/2" wide grip material on Kenny's aluminum barrel :D

So - 8 1/2 feet (a li'l extra for error) is whatcha need.
 
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

H
Boots Need help with ROTJ boots
Replies
1
Views
132
lowberg
lowberg
H
Need help with codpiece
Replies
2
Views
64
Harvey
H
bobafetish
ROTJ Paint codes
Replies
11
Views
209
bobafetish
bobafetish
AdenSolu
A'den Solu's ROTJ SE Build
2
Replies
21
Views
617
AdenSolu
AdenSolu
PhantomBlade
PhantomBlade finally builds a ROTJ Fett
2
Replies
27
Views
1,013
PhantomBlade
PhantomBlade
Back
Top