Reply to thread

Hello,

 

I have to say that I am very impressed with the quality of the work being done on the flame thrower, it is a thing of beauty.  I can't wait to see the finial product all assembled and installed on a gauntlet.

 

There has been some interest in the backplate so here is the drawing in PDF, just print it out on standard 8.5"X11" paper and it will be in scale with the flamethrower.  If you have any issues with it just let me know.

 

http://home.comcast.net/~wizardofflight/Flame_Thrower_Backplate.pdf

 

Have a great day.

 

Alan


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top