Reply to thread

Dude not to be negative but you can get resin ones that are casts of actual parts then rub n buff em theyll look great, just because the stuff your using is metal doesnt make it better...the jacks are more accurate in size than u may think...the "darts" on the gaunts are the size of the ink of a pen maybe 1/8 inch in diameter


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top