Reply to thread

I made my first boots out of a pair of Converse All Stars.  I squared the toe with plumber's putty, and covered the shoe with fabric and piping.  I covered the sole and the edge of the fabric with some rubber mastic tape I painted off white.  The spikes are sharpened nylon bolts and a piece of styrene.  The only $$ part was getting a zipper sewn in, about $80 at a shoe repair store.  I'll be selling them soon as I'm almost done with my Jango Wes boots.



This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top