Reply to thread

Message

As far as "mixing" it really depends on what kind of paint you're using. I know for example the Testors Model Master paints technically don't need to be thinned at all before shooting them. I used them straight out of the bottle for my ESB helmet and didn't have any problems.
Other paints have different recommendations based on the manufacturer. Like the Polly Scale paints recommend using distilled water as a thinning medium.
Eric

[QUOTE="superjedi, post: 64258, member: 303"] As far as "mixing" it really depends on what kind of paint you're using. I know for example the Testors Model Master paints technically don't need to be thinned at all before shooting them. I used them straight out of the bottle for my ESB helmet and didn't have any problems. Other paints have different recommendations based on the manufacturer. Like the Polly Scale paints recommend using distilled water as a thinning medium. Eric [/QUOTE]

This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification