Reply to thread

i mad my Armour from simtra used WOFs fantastic stencils , i printed at 105% because im a larger chap heres a rough fit of the armour ( sorry for looking miserable) does to collar look right ,in the secon pic ive erased a section , would it look better trimmed or should i leave it , the armour was just a rough fit onto the velcro on the vest


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top