Reply to thread

Queso has the process down pat for sure.  My only suggestion would be to do a coat (or two) of rondo on the inside prior to fiberglass/resin combo.  This will round off the inside sharp corners and provide a better surface for the fiberglass/resin to stick to.


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top