Reply to thread

I used Goop, that is found at any hardware store and some small philip head scews. So I glued it down and used some rubber ended C-clamps to hold it down tight and put the scews in from the inside. Small enough not to poke through. I just pre-drilled the holes in the helmet and marked the location on the ear parts and started a small hole there for the screw to go in. Seems to hold just fine.


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top