Reply to thread

Here is the promised stencil. Please note that this is only for use in seeing if they will work for your helmet. Just print, cut out and tape to your bucket! You must print them at 100% of size to work.


http://www.evan4218.com/images/Fettearcap.pdf


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top