Reply to thread

That's nearer to the attachment method we think was used on the original prop.  The pins go in the holes and mate the inner and outer RF ear caps, but I seriously doubt magnets were used on the original helmet.  The pins are more understandable on the real helmet's machined ears.


I always like to see the insides of a prop duplicated as much as the outside, even if they are never seen.  Glad you like 'em!


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top