Reply to thread

I did size it and mark it to trim, but in doing so, alot is overlapped and will need to get cut off. This puts alot of pressure do to the now oval (rather than round) shape at the knee and I am afraid velcro will not hold. I was thinking of ABS cementing the thigh closed and just slipping them on.

 

What type of heat gun should I use?


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top