Reply to thread

I have a set of ABS Trooper armor (FX) and when putting the thigh together I noticed that the lower part of the thigh is way to wide. It makes the thigh armor look boxy.

 

Is there a way of heating the ABS up taper the thigh so it is more form fitting?

 

I appreciate any help from those ABS experts out there.:)


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top