Reply to thread

I have recently acquired fettprides molds for Jango fett taken directly off a casting from the original molds used to make the real movie helmet. Any thing available till now have been at BEST 4th of 5th gen and because of that much smaller helmets. This one actually fits on your head properly lol. I cast this one up in high quality fiberglass cold cast. It only took five minutes and buffed it out nice with some steel wool. I will give it a more better polish once the paint is done. Here it masked up and primed, I also have the first color on but still need to get a pic with the first color. More to come...

[ATTACH=full]131183[/ATTACH]

[ATTACH=full]131184[/ATTACH]

[ATTACH=full]131185[/ATTACH]

[ATTACH=full]131186[/ATTACH]

[ATTACH=full]131187[/ATTACH]

[ATTACH=full]131188[/ATTACH]


This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top