Reply to thread

Hi ppl


Quick up date on the blaster progess.


As can be seen the main body of the Webley is constructed from wood.  I basically layered sections together and sanded to shape.


The barrel was made from 50mm telecom ducting and a chrome exhaust pipe from the local auto centre.


The scope was purchase from Ebay (the oly part of the blaster which has not been scratch built), it is similar to a Tasco 4x20.  The mounts were made from 18mm wide sections of the 50mm pipe.  These were cut and heated to make flat pieces which i then folded to shape, i added screws to the centres for support.


The stock connector was made from a 4mm thick road sign (see pic) and attached to the scratch built stock (just a piece of old timber i had in the shed).


Well thats just about it until i add the trigger and greeblies.  enjoy.


[ATTACH=full]3311[/ATTACH]


[ATTACH=full]3312[/ATTACH]


[ATTACH=full]3313[/ATTACH]


[ATTACH=full]3314[/ATTACH]


[ATTACH=full]3315[/ATTACH]


[ATTACH=full]3316[/ATTACH]


[ATTACH=full]3317[/ATTACH]


[ATTACH=full]3318[/ATTACH]


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top